[1]魏新利,张海红,王定标,等.旋风分离器内颗粒轨迹的数值模拟[J].郑州大学学报(工学版),2004,25(03):14-17,59.[doi:10.3969/j.issn.1671-6833.2004.03.004]
 WEI Xinli,ZHANG Haihong,Wang Dingping,et al.Numerical simulation of particle trajectories within a cyclone[J].Journal of Zhengzhou University (Engineering Science),2004,25(03):14-17,59.[doi:10.3969/j.issn.1671-6833.2004.03.004]
点击复制

旋风分离器内颗粒轨迹的数值模拟()
分享到:

《郑州大学学报(工学版)》[ISSN:1671-6833/CN:41-1339/T]

卷:
25卷
期数:
2004年03期
页码:
14-17,59
栏目:
出版日期:
1900-01-01

文章信息/Info

Title:
Numerical simulation of particle trajectories within a cyclone
作者:
魏新利张海红王定标等.
郑州大学化工学院,河南,郑州,450002, 郑州大学化工学院,河南,郑州,450002, 郑州大学化工学院,河南,郑州,450002, 郑州大学化工学院,河南,郑州,450002
Author(s):
WEI Xinli; ZHANG Haihong; Wang Dingping; etc
关键词:
旋风分离器 数值模拟 耦合 轨迹
Keywords:
DOI:
10.3969/j.issn.1671-6833.2004.03.004
文献标志码:
A
摘要:
采用数值模拟的方法研究旋风分离器内的颗粒运动:对单相流场采用湍流各向异性的雷诺应力模型,对气、固两相流场采用相间耦合的随机轨道模型;通过描述颗粒的运动轨迹,揭示了颗粒在旋风分离器中运动的物理机制.结果表明:颗粒的运动轨迹比较复杂,且带有很大的随机性;尤其是小粒径颗粒,受气流湍动影响显著,即使是粒径、入射位置相同,其运动轨迹也各不相同,最终的位置也不同;小粒径颗粒更容易受二次涡流影响,从而降低分离器的效率;另外,还模拟出了上灰环、排气管短路流及排尘口返混等影响分离效率的几种现象,为进一步研究旋风分离器的分离机理理论及实验研究打下基础.
Abstract:
The particle motion in the cyclone was studied by numerical simulation: the Reynauds stress model of turbulent anisotropy was used for the single-phase flow field, and the random orbital model with phase-coupled phase coupling was adopted for the gas-solid two-phase flow field. By describing the motion trajectory of particles, the physical mechanism of particle movement in the cyclone separator is revealed. The results show that the motion trajectories of particles are complex and have great randomness. In particular, small particle size particles are significantly affected by air turbulence, even if the particle size and incidence position are the same, their motion trajectories are different, and the final position is also different; Particles with small particle sizes are more susceptible to secondary eddy currents, which reduces the efficiency of the separator; In addition, several phenomena affecting the separation efficiency, such as upper ash ring, exhaust pipe short-circuit flow and dust outlet remixing, are also simulated, which lays a foundation for further research on the separation mechanism theory and experimental research of cyclone separator.

相似文献/References:

[1]时刚,田新涛.工程卡车行驶引发地面振动特性研究[J].郑州大学学报(工学版),2020,41(05):76.[doi:10.13705/j.issn.1671-6833.2020.03.017]
 Shi Gang,Tian Xintao..Research on Ground Vibration Characteristics Caused by Engineering Truck Driving[J].Journal of Zhengzhou University (Engineering Science),2020,41(03):76.[doi:10.13705/j.issn.1671-6833.2020.03.017]
[2]戴逸飞,杨 平,王 宁,等.交叠车站下穿段MJS加固温度场变化规律研究[J].郑州大学学报(工学版),2023,44(01):103.[doi:10.13705/j.issn.1671-6833.2022.04.002]
 DAI Yifei,YANG Ping,WANG Ning,et al.Study on Temperature Field Variation Law of MJS Reinforcement for Underpass Section of Overlapping Station[J].Journal of Zhengzhou University (Engineering Science),2023,44(03):103.[doi:10.13705/j.issn.1671-6833.2022.04.002]
[3]王定标,万方方,周俊杰..蒸发式冷凝器异型扁管性能分析及数值模拟[J].郑州大学学报(工学版),2010,31(02):67.[doi:10.3969/j.issn.1671-6833.2010.02.016]
 Wang Dingping,Wanfangfang,Zhou Junjie.Performance analysis and numerical simulation of special-shaped flat tube of evaporative condenser[J].Journal of Zhengzhou University (Engineering Science),2010,31(03):67.[doi:10.3969/j.issn.1671-6833.2010.02.016]
[4]董其伍,王烨,刘敏珊..流动冲击角对流体绕流管束换热的影响[J].郑州大学学报(工学版),2010,31(02):0.[doi:10.3969/j.issn.1671-6833.2010.02.017]
 Dong Qiwu,WANG Ye,Liu Minshan.The effect of flow impact angle on heat transfer around the flow tube bundle[J].Journal of Zhengzhou University (Engineering Science),2010,31(03):0.[doi:10.3969/j.issn.1671-6833.2010.02.017]
[5]王丹,董其伍,刘敏珊..管壳式换热器模块综合模拟方法研究[J].郑州大学学报(工学版),2010,31(03):20.[doi:10.3969/j.issn.1671-6833.2010.03.006]
 WANG Dan,Dong Qiwu,Liu Minshan.Research on comprehensive simulation method of shell and tube heat exchanger module[J].Journal of Zhengzhou University (Engineering Science),2010,31(03):20.[doi:10.3969/j.issn.1671-6833.2010.03.006]
[6]李成,马志垒,王永涛..冲击荷载下防弹钢板三维损伤分析[J].郑州大学学报(工学版),2010,31(04):85.[doi:10.3969/j.issn.1671-6833.2010.04.021]
[7]王定标,雷风林,向飒,等.汽轮机末级变工况三维数值模拟与叶型改进设计[J].郑州大学学报(工学版),2010,31(05):1.[doi:10.3969/j.issn.1671-6833.2010.05.001]
[8]张兆宁,贺拴海,赵煜..基于应力控制箱梁截面设计数值模拟分析[J].郑州大学学报(工学版),2010,31(06):65.[doi:10.3969/j.issn.1671-6833.2010.06.016]
[9]汪磊,李涛..海底隧道穿越断层破碎带预注浆加固稳定性分析[J].郑州大学学报(工学版),2010,31(06):73.[doi:10.3969/j.issn.1671-6833.2010.06.018]
[10]魏新利,张富强,简士钊,等.以制冷剂R22为工质的地板辐射采暖模拟与优化[J].郑州大学学报(工学版),2011,32(02):6.[doi:10.3969/j.issn.1671-6833.2011.02.002]
[11]魏新利,张海红,王定标..旋风分离器流场的数值计算方法研究[J].郑州大学学报(工学版),2005,26(01):57.[doi:10.3969/j.issn.1671-6833.2005.01.015]
 WEI Xinli,ZHANG Haihong,Wang Dingjiao.Research on numerical calculation method of cyclone flow field[J].Journal of Zhengzhou University (Engineering Science),2005,26(03):57.[doi:10.3969/j.issn.1671-6833.2005.01.015]

更新日期/Last Update: 1900-01-01