[1]夏毅敏,周喜温,刘玉江,等.某型土压平衡盾构刀盘有限元分析[J].郑州大学学报(工学版),2009,30(03):70-74.[doi:10.3969/j.issn.1671-6833.2009.03.018]
　XIA Yimin,ZHOU Xiwen,LIU Yujiang,et al.Finite element analysis of cutterhead of a certain type of EPB shield[J].Journal of Zhengzhou University (Engineering Science),2009,30(03):70-74.[doi:10.3969/j.issn.1671-6833.2009.03.018]
点击复制

某型土压平衡盾构刀盘有限元分析()
分享到：

《郑州大学学报(工学版)》[ISSN:1671-6833/CN:41-1339/T]

卷:
30卷
期数:
2009年03期
页码:
70-74
栏目:
出版日期:
1900-01-01

文章信息/Info

Title:
Finite element analysis of cutterhead of a certain type of EPB shield
作者:
夏毅敏; 周喜温; 刘玉江; 等.
中南大学,材料科学与工程学院,湖南,长沙,410083;中南大学,现代复杂装备设计与极端制造重点实验室,湖南,长沙,410083, 中南大学,现代复杂装备设计与极端制造重点实验室,湖南,长沙,410083, 中铁十四局集团有限公司隧道分公司,山东,济南,250002
Author(s):
XIA Yimin; ZHOU Xiwen; LIU Yujiang; etc
关键词:
盾构;  刀盘;  有限元分析;  结构分析
Keywords:
DOI:
10.3969/j.issn.1671-6833.2009.03.018
文献标志码:
A
摘要:
根据某土压平衡盾构刀盘结构特点,在Solidworks中建立其三维实体模型,并应用ANSYS软件建立了刀盘相应的有限元计算模型,对刀盘在正常工况和脱困工况下的受力特性进行分析,得到了刀盘在各工况下的应力应变分布规律.分析结果表明,危险截面位于180～210°辅梁与辅条间,在牛腿与法兰盘、辅梁连接处也有较大应力,最大应力为204 MPa,最大变形为1.568 mm,研究结果为刀盘的结构设计和工程施工维护提供了基础数据.
Abstract:
According to the structural characteristics of a cutterhead of an EPB shield, a three-dimensional solid model was established in Solidworks, and the corresponding finite element calculation model of the cutterhead was established by ANSYS software, and the stress and strain distribution law of the cutterhead under normal working conditions and escape conditions was analyzed, and the stress-strain distribution law of the cutterhead under each working condition was obtained. The analysis results show that the dangerous section is located between the auxiliary beam and the auxiliary bar at 180~210°, and there is also a large stress at the connection between the corbel, the flange plate and the auxiliary beam, the maximum stress is 204 MPa, and the maximum deformation is 1.568 mm, and the research results provide basic data for the structural design and engineering construction maintenance of the cutterhead.

相似文献/References:

[1]夏毅敏,杨添任,黄秀祥..回转式盾构刀具切削性能测试平台监控系统设计[J].郑州大学学报(工学版),2011,32(06):79.[doi:10.3969/j.issn.1671-6833.2011.06.019]
[2]夏毅敏,何利,谢敬华,等.管道特性对盾构推进缸位移影响的数值分析[J].郑州大学学报(工学版),2013,34(01):82.[doi:10.3969/j.issn.1671-6833.2013.01.020]
[3]郭庆海,刘文,胡群芳,等.盾构施工对沥青路面影响评估[J].郑州大学学报(工学版),2004,25(03):70.[doi:10.3969/j.issn.1671-6833.2004.03.017]
　GUO Qinghai,LIU Wen,HU Qunfang,et al.Impact assessment of shield construction on asphalt pavement[J].Journal of Zhengzhou University (Engineering Science),2004,25(03):70.[doi:10.3969/j.issn.1671-6833.2004.03.017]

更新日期/Last Update: 1900-01-01