[1]任晨星,孙玉峰,汤亚力,等.快凝Al-Cr合金的显微结构与形核动力学[J].郑州大学学报(工学版),2002,23(03):87-90.[doi:10.3969/j.issn.1671-6833.2002.03.024]
　Ren Chenxing,SUN Yufeng,Tang Yali,et al.Microstructure and nucleation dynamics of fast-setting Al-Cr alloy[J].Journal of Zhengzhou University (Engineering Science),2002,23(03):87-90.[doi:10.3969/j.issn.1671-6833.2002.03.024]
点击复制

快凝Al-Cr合金的显微结构与形核动力学()
分享到：

《郑州大学学报(工学版)》[ISSN:1671-6833/CN:41-1339/T]

卷:
23
期数:
2002年03期
页码:
87-90
栏目:
出版日期:
1900-01-01

文章信息/Info

Title:
Microstructure and nucleation dynamics of fast-setting Al-Cr alloy
作者:
任晨星; 孙玉峰; 汤亚力; 等.
郑州大学材料工程学院,河南,郑州,450002, 北京科技大学材,料学院,北京,100083
Author(s):
Ren Chenxing; SUN Yufeng; Tang Yali; etc
关键词:
快速凝固;  Al-Cr合金;  竞相形核;  相选择;  连续过 冷
Keywords:
DOI:
10.3969/j.issn.1671-6833.2002.03.024
文献标志码:
A
摘要:
用连续冷却的方法对Al-(1～5)Cr(质量分数)快凝合金的形核动力学及显微结构进行了计算与研究,得出了在不同成分、不同冷却速度下的形核孕育期与冷却速度之间的关系,从而得出了凝固过程中的相选择规律,即某相的优先析出是由于其形核动力学条件较其他相更具优势所致.具体到Al-Cr合金,则随着溶质含量的提高,抑制金属间化合物相首先形核所需的临界冷速增大,也即完全过饱和单相α-Al的组织只能在很大的冷速或极薄的条带中形成,且计算结果与实验检测吻合较好.
Abstract:
The nucleation dynamics and microstructure of Al-(1~5)Cr (mass fraction) fast-setting alloy were calculated and studied by continuous cooling, and the relationship between the nucleation gestation period and the cooling rate under different components and different cooling rates was obtained, and the phase selection law in the solidification process was obtained, that is, the preferential precipitation of a certain phase was caused by its nucleation kinetic conditions being more advantageous than other phases. Specific to Al-Cr alloys, with the increase of solute content, the critical cold rate required to inhibit the first nucleation of intermetallic phase increases, that is, the tissue of completely supersaturated single-phase α-Al can only be formed in a large cold rate or a very thin band, and the calculation results are in good agreement with experimental detection.

相似文献/References:

[1]石广新,张国胜,关绍康,等.Ni20Zr10Al70非晶合金的制备技术及组织的研究[J].郑州大学学报(工学版),2004,25(04):49.[doi:10.3969/j.issn.1671-6833.2004.04.013]
　SHI Guangxin,Zhang Guosheng,Guan Shaokang,et al.Study on preparation technology and microstructure of Ni20Zr10Al70 amorphous alloy[J].Journal of Zhengzhou University (Engineering Science),2004,25(03):49.[doi:10.3969/j.issn.1671-6833.2004.04.013]
[2]汤亚力,沈宁福,关绍康,等.快速凝固 Al-Fe 合金中准晶相的研究[J].郑州大学学报(工学版),1998,19(03):7.
　Tang Yali,Shen Ningfu,Guan Shaokang,et al.Research on quasi-crystalline phase in AL-FE alloys[J].Journal of Zhengzhou University (Engineering Science),1998,19(03):7.
[3]杨明珊,汤亚力,沈宁福,等.快速凝固热强Al-4Ti-2V-3La合金的显微结构和力学性能的研究[J].郑州大学学报(工学版),1997,18(01):32.
　Yang Mingshan,Tang Yali,Shen Ningfu,et al.Research on the microstructure and mechanical performance of fast solidifying thermal AL-4TI-2V-3LA alloy[J].Journal of Zhengzhou University (Engineering Science),1997,18(03):32.
[4]石广新,沈宁福,任晨星.常规和快速凝固Al－3．18Ti－0．65C合金中TiC相的形成机理[J].郑州大学学报(工学版),1996,17(01):13.
　Shi Guangxin,Shen Ningfu,Ren Chenxing.Conventional and fast solidification AL -3.18Ti -0.65c The formation mechanism of TIC phases in the alloy[J].Journal of Zhengzhou University (Engineering Science),1996,17(03):13.
[5]汤亚力,沈宁福,张东捷,等.Al—8Fe－3Ti急冷合金的组织稳定性[J].郑州大学学报(工学版),1995,16(01):88.
　Tang Yali,Shen Ningfu,Zhang Dongjie,et al.The tissue stability of AL -8FE -3TI -cold alloy[J].Journal of Zhengzhou University (Engineering Science),1995,16(03):88.
[6]汤亚力,沈宁福,邵国胜,等.用分析电子显微镜研究快速凝固A18Fe4Ce3Ti合金中的未知相[J].郑州大学学报(工学版),1991,12(04):58.
　Tang Yali,Shen Ningfu,Shao Guosheng,et al.Use an analytical electronic microscope to study the unknown phase in the A18FE4CE3TI alloy[J].Journal of Zhengzhou University (Engineering Science),1991,12(03):58.
[7]仝兴存,沈宁福.快速凝固Al-Si-Ti-Pb合金中Pb的沉淀特征[J].郑州大学学报(工学版),1990,11(03):1.
　Same Story,Shen Ningfu,Quickly solidify the precipitation characteristics of PB in PB in Al-Si-Ti-PB alloys[J].Journal of Zhengzhou University (Engineering Science),1990,11(03):1.

更新日期/Last Update: 1900-01-01